Section 49 (Convertible Top)
WARNING: This page is about a different car, the 2011 Saab 9-3 and 2010 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
- Repair Instructions
- Adjustment
- Adjustment principles
- Adjustment procedure
- Boot lid adjustment, CV
- Adjustment, soft top cover
- Adjusting the soft top and first bow lock hooks
- Adjustment of windows and door mirror base seal, CV
- Notes
- Checking the door window highest position
- Adjustment of the door window, uppermost position
- Checking the position of the door window, forward/backward
- Adjustment of the door window forwards /backwards
- Checking the depth of the door window travel
- Adjustment of the door window inwards / outwards
- Checking the door mirror base seal
- Adjusting door mirror base forwards / backwards, outwards/inwards
- Checking the side window
- Adjustment of the side window forwards / backwards
- Adjustment of the side window inwards / outwards
- Adjustment of the side window, uppermost position
- Complete soft top (with hydraulic unit)
- Soft top cover
- Soft top cover, hinge
- Soft top cover, molding
- Soft top cover, cover strip
- Outer weatherstrip, side window and weatherstrip, soft top cover, CV
- Soft top storage
- Soft top storage drive with locks
- Lock for soft top storage drive
- Control module, STC (565)
- Hydraulic unit
- Motor, hydraulic pump, soft top (646)
- Drive clutch, hydraulic pump
- Hydraulic unit, fluid reservoir
- Solenoid valve (647a/b/c)
- Hydraulic lines
- Soft top cover hydraulic cylinder
- Hydraulic cylinder for locking first bow
- Soft top hydraulic cylinder
- Sixth bow hydraulic cylinder
- Replacing the hydraulic lines and wiring harness, front bow
- Checking/filling oil
- Draining, filling and bleeding the hydraulic system
- Front rail side seal
- Middle rail seal
- Rear rail/sixth bow seal
- Rear window mechanism, CV
- Second bow
- Third bow
- Reinforcing bow
- Fourth bow
- Fifth bow
- Sixth bow
- Soft top cover, headlining and rear window
- Headlining
- Position sensor, first bow ready to lock (561)
- Position sensor, first bow locked (561c)
- Adjustment of position sensor, first bow locked (561c)
- Position sensor, soft top cover locked (562LH/RH)
- Position sensor, soft top locked, check
- Position sensor, soft top cover open (562o)
- Position sensor, soft top storage down (564)
- Position sensor, soft top raised and soft top lowered (577c/o)
- Position sensor, sixth bow locked, left and right (578LH/RH)
- Position sensor, sixth bow raised (578u)
- Latch fittings, windscreen frame
- First bow lock hooks
- Emergency operation
- Replacing connecting tab on electrically heated rear window, CV
- Cleaning the outer roof, soft top
- Description and Operation
- Soft-top system, brief description
- Soft top system, main components
- Soft top system, detailed description
- Soft top operation, brief description
- Soft top operation, main components
- Soft top operation, detailed description
- Hydraulic system
- Pump unit
- Valves
- Hydraulic functions for opening soft top
- Soft top sequences, opening the soft top, hydraulic functions
- Soft top sequences, closing the soft top, hydraulic functions
- Electro-hydraulic system
- Conditions for soft top operation
- Soft top sequences, opening the soft top, sensor inputs
- Soft top sequences, closing the soft top, sensor inputs
- Window operation, opening the soft top
- Window operation, closing the soft top,
- SID, text messages
- Position sensor, first bow ready to lock (561)
- Position sensor, first bow locked, (561c)
- Position sensor, soft top cover locked, LH (562LH)
- Position sensor, soft top cover locked, RH (562RH)
- Position sensor, soft top lowered (562o)
- Position sensor, soft top bag down (564)
- Control module, STC (565)
- Position sensor, soft top raised (577c)
- Position sensor, soft top lowered (577o)
- Position sensor, sixth bow locked, LH (578LH)
- Position sensor, sixth bow locked, RH (578RH)
- Position sensor, sixth bow raised, (578u)
- Motor, hydraulic pump, soft top (646)
- Solenoid valve 1, 2, 3, soft top (647a, b, c)
- Component Locator
- Switch, convertible soft top (317)
- Position sensor, first bow ready to lock (561)
- Position sensor, first bow locked (561c)
- Position sensor, soft top cover locked, LH (562LH)
- Position sensor, soft top cover locked, RH (562RH)
- Position sensor, soft top lowered (562o)
- Position sensor, soft top bag down (564)
- Control module, STC (565)
- Position sensor, soft top raised (577c)
- Position sensor, soft top lowered (577o)
- Position sensor, sixth bow locked, LH (578LH)
- Position sensor, sixth bow locked, RH (578RH)
- Position sensor, sixth bow raised (578u)
- Motor, hydraulic pump, soft top (646)
- Solenoid valve 1, soft top (647a)
- Solenoid valve 2, soft top (647b)
- Solenoid valve 3, soft top (647c)
- Rear electrical center 701 (REC)
- Fuse 5, rear electrical center 701, maxi-fuse
- Switch panel (737a)
- Crimp connection J68, instrument harness
- Crimp connection J70, instrument harness
- Crimp J174, soft top wiring harness
- Crimp connection J175, soft top harness
- Crimp J201, main wiring harness CV
- Grounding point G40
- Grounding point G48 (CV)
- Specifications
- Test readings, STC control module
- Pump block, hydraulic unit
- Hydraulic lines
- 1st bow hydraulic cylinder, locking
- Main hydraulic cylinder, left/right
- 6th bow hydraulic cylinder, left/right
- Soft top cover hydraulic cylinder, left/right
- Position sensor, first bow locked (561c)
- Position sensor, soft top cover locked, LH (562LH)
- Position sensor, soft top cover locked, RH (562RH)
- Position sensor, soft top lowered (562o)
- Position sensor, soft top bag down (564)
- Control module, STC (565)
- Position sensor, soft top raised (577c)
- Position sensor, soft top lowered (577o)
- Position sensor, sixth bow locked, LH (578LH)
- Position sensor, sixth bow locked, RH (578RH)
- Position sensor, sixth bow raised (578u)
- Motor, hydraulic pump, soft top (646)
- Solenoid valve 1, 2, 3, soft top (647a, b, c)
- Tightening torque
- Special Tools and Equipment
- Fault Diagnosis, General
- Testing for open/short circuits
- General
- Testing for open circuits by measuring resistance
- Testing for short circuits to ground
- Diagnostic Concept
- Fault diagnosis strategy for electronic systems
- Procedures before dismantling the control module
- Measures after changing the control module
- Actions when replacing electrical components
- Connectors, handling and checking
- Testing for open/short circuits
- Schematic and Routing diagrams