LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2010 >> 9-3X Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Convertible Top) >> Repair Instructions >> Latch fittings, windscreen frame >> Fitting

Latch fittings, windscreen frame: Fitting

WARNING: This page is about a different car, the 2011 Saab 9-3 and 2010 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Left-hand side:  Fit the position sensor where appropriate.
  2. Put the lock fitting in mounting position.
  3. Fit the latch fitting bolts.
    Fig 1: Illustration For Step 3-4
    G05566751Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Left-hand side:  Plug in the position sensor connector. Put the sensor in mounting position on the latch fitting and fit it.
  5. Test the operation of the soft top.
  6. Fit the Windscreen frame upper trim. See WINDSCREEN FRAME UPPER TRIM, CV .
  7. Close the soft top.
  8. Connect the diagnostics tool and erase any diagnostic trouble code.
scientia non olet · About LEMON Manuals