LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2010 >> 9-3X Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Convertible Top) >> Repair Instructions >> Position sensor, soft top storage down (564) >> To fit

To fit

WARNING: This page is about a different car, the 2011 Saab 9-3 and 2010 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit the sensor to the plastic holder.
  2. Hook the sensor cable to the holder.
  3. Fit the position sensor with plastic holder to the soft top storage drive.
    Fig 1: Illustration For Step 3-4
    G05063608Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Plug in the position sensor connector.
    IMPORTANT: Cables to hydraulic lines and position sensors must be refitted as they were earlier or there will be a risk of them being damaged when the soft top and soft top cover are operated.
  5. The position sensor connector must be located behind the hose package so it does not catch on the mechanism.
  6. Fit the bolts for the soft top storage drive mechanism.
    Fig 2: Illustration For Step 6-7
    G05063609Courtesy of SAAB-SCANIA OF AMERICA, INC.
  7. Fit the soft top storage side bolts.
  8. Remove the soft top support and raise the soft top.
  9. Test the operation of the soft top.
  10. Connect the diagnostics tool and erase any diagnostic trouble code.
scientia non olet · About LEMON Manuals