Soft top cover hydraulic cylinder: Fitting

WARNING: This page is about a different car, the 2011 Saab 9-3 and 2010 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.

Fit the position sensor if the right-hand hydraulic cylinder has been changed.

Fig 1: Identifying Position Sensor
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Remove the O-rings of the hydraulic cylinder using a blunt tool. Check the O-rings and replace as necessary. Then fit the O-rings on the hydraulic lines before refitting the lines on the hydraulic cylinder. Use only one O-ring per hydraulic line.

Fig 2: Locating O-Ring
Courtesy of SAAB-SCANIA OF AMERICA, INC.

Attach the hydraulic lines to the hydraulic cylinder by pressing them in.

Fig 3: Illustration For Step 2-3
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Press on the hydraulic line retaining clips.
Place the hydraulic cylinder in position for fitting. Fit the fastening pin to the hydraulic cylinder piston rod. Fit the accompanying washer (if any).

Fig 4: Illustration For Step 4-6
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the fastening pin to the hydraulic cylinder. Take note of the accompanying washers (if any). The washer should be placed against the cylinder.
Fit the clip to the fastening pin.
Fit the cable ties to the position sensor cable on the right-hand side.
Remove the soft top support and raise the soft top.
Open and close the soft top for 5 complete cycles to bleed the system and check its function.
Check for any fluid leaks.
Check the oil level and top up as necessary. See CHECKING/FILLING OIL .
Fit Luggage compartment side trim. See LUGGAGE COMPARTMENT TRIM, CV .
Connect the diagnostics tool and erase any diagnostic trouble code.