Section 3 (Manual Transmission - TREMEC 6-Speed (M13 MJK Mm6 MH3))
WARNING: This page is about a different variant/trim than selected.
- Specifications
- Fastener Specifications (M13)
- Fastener Specifications (MJK, MH3, or MM6)
- Approximate Fluid Capacities (MJK, MH3, or MM6)
- Approximate Fluid Capacities (M13)
- Adhesives, Fluids, Lubricants, and Sealers (MJK, MH3, or MM6)
- Adhesives, Fluids, Lubricants, and Sealers (M13)
- Shim Size Specifications
- Temperature Versus Resistance - B173 Manual Transmission Fluid Temperature Sensor
- Schematic Wiring Diagrams
- Visual Identification
- Diagnostic Information and Procedures
- DTC P0502 or P0503
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0712 or P0713
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0729 or P0731-P0735
- DTC P0801, P088C, or P088D
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0803, P080C, or P080D
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P080A
- DTC P08A8-P08AA
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P08AC
- DTC P18C4-P18C9
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P18CA
- DTC P17A2 (LT1, LT4)
- DTC P17A2 (LTG, LGX)
- Symptoms - Manual Transmission (MJK, MH3, or MM6)
- Symptoms - Manual Transmission (M13)
- Transmission Shifts Hard (MJK, MH3, or MM6)
- Transmission Shifts Hard (M13)
- Transmission Gear Clash When Shifting Gears
- Transmission Noisy (MJK, MH3, or MM6)
- Transmission Noisy (M13)
- Transmission Jumps Out of Gear
- Transmission Does Not Shift into One Gear
- Transmission Locked in One Gear
- Transmission Clunk on Acceleration or Deceleration
- Transmission Fluid Leak Diagnosis
- DTC P0502 or P0503
- Repair Instructions - On Vehicle
- Clutch Pedal Position Learn
- Excessive Clutch Slip Data Reset
- Gear Position Sensor Learn
- Transmission Fluid Level Inspection (MH3, MJK, MM6)
- Transmission Fluid Level Inspection (M13 Without Y4Q)
- Transmission Fluid Level Inspection (M13 With Y4Q Track Pack With or Without KNR)
- Transmission Mount Inspection
- Transmission Rear Mount Replacement (MH3, MJK, MM6 Transmission)
- Transmission Rear Mount Replacement (M13 Transmission)
- Transmission Control Lever Lower Boot Replacement
- Transmission Control Lever Boot Replacement
- Transmission Control Replacement (MH3, MJK, MM6)
- Transmission Control Replacement (M13)
- Transmission Control Lever Knob Replacement
- Main Shaft Rear Seal Replacement
- Backup Lamp Switch Replacement
- Transmission Neutral Position Sensor Replacement
- Shift Fork Position Sensor Replacement
- Transmission Fluid Temperature Sensor Replacement
- Vehicle Speed Sensor Replacement (M13)
- Vehicle Speed Sensor Replacement (MH3, MJK, MM6)
- Reverse Lockout Solenoid Replacement
- Gear Select/Skip Shift Solenoid Replacement
- Transmission Fluid Drain and Fill (M13 Without Y4Q)
- Transmission Fluid Drain and Fill (MH3, MJK, MM6)
- Transmission Fluid Drain and Fill (M13 With Y4Q Track Pack With or Without KNR)
- Transmission Replacement (MM6 with LT1 Engine, MH3 or MJK with LT4 Engine)
- Transmission Replacement (M13 with LGX Engine)
- Transmission Replacement (M13 with LTG Engine)
- Repair Instructions - Off Vehicle
- Transmission Disassemble (M13 - LGX with Y4Q)
- Transmission Disassemble (MJK, MH3, or MM6)
- Transmission Disassemble (M13 - LGX without Y4Q, LTG)
- Main Shaft and Input Shaft Disassemble (M13)
- Main Shaft and Input Shaft Disassemble (MJK, MH3, or MM6)
- Counter Gear Shaft Disassemble (MJK, MH3, or MM6)
- Counter Gear Shaft Disassemble (M13)
- Synchronizers Disassemble (MJK, MH3, or MM6)
- Synchronizers Disassemble (M13)
- Synchronizers Cleaning and Inspection
- Synchronizers Assemble (MJK, MH3, or MM6)
- Synchronizers Assemble (M13)
- Shift Shaft and Fork Assemblies Disassemble (MM6)
- Shift Shaft and Fork Assemblies Cleaning and Inspection (MJK, MH3, or MM6)
- Shift Shaft and Fork Assemblies Cleaning and Inspection (M13)
- Shift Shaft and Fork Assemblies Assemble (MM6)
- Transmission Case and Clutch Housing Disassemble (MJK, MH3, or MM6)
- Transmission Case and Clutch Housing Disassemble (M13)
- Transmission Case and Clutch Housing Cleaning and Inspection (M13)
- Transmission Case and Clutch Housing Cleaning and Inspection (MJK, MH3, or MM6)
- Transmission Case and Clutch Housing Assemble (MJK, MH3, or MM6)
- Transmission Case and Clutch Housing Assemble (M13)
- Clutch Housing Shift Shaft Bearing and Input Shaft Seal Installation
- Transmission Fluid Pump and Inlet Tube Installation
- Clutch Housing Bearing Race and Shim Installation
- Manual Transmission Vent Installation
- Transmission Case Shift Shaft Bearing Installation
- Transmission Case Bearing Race and Shift Control Components Installation
- Shift Control Shaft Cover Assembly Disassemble (MM6)
- Shift Control Shaft Cover Assembly Assemble (MM6)
- Extension Disassemble (MJK, MH3, or MM6)
- Extension Disassemble (M13)
- Extension Cleaning and Inspection (MJK, MH3, or MM6)
- Extension Cleaning and Inspection (M13)
- Extension Assemble (MJK, MH3, or MM6)
- Extension Assemble (M13)
- Bearings and Spacers Cleaning and Inspection
- Gears Cleaning and Inspection
- Counter Gear Shaft Assemble (MJK, MH3, or MM6)
- Counter Gear Shaft Assemble (M13)
- Main Shaft and Input Shaft Assemble (M13)
- Main Shaft and Input Shaft Assemble (MJK, MH3, or MM6)
- Transmission Assemble (M13 - LGX with Y4Q)
- Transmission Assemble (MJK, MH3, or MM6)
- Transmission Assemble (M13 - LGX without Y4Q, LTG)
- Shimming Procedures (MJK, MH3, or MM6)
- Shimming Procedures (M13)
- Description and Operation
- Transmission Identification Information
- Manual Transmission Description and Operation (M13)
- Manual Transmission Description and Operation (MM6)
- Manual Transmission Description and Operation (MJK)
- Manual Transmission Description and Operation (MH3)
- Manual Transmission Protection Description and Operation
- Reverse Inhibit Description and Operation
- Skip Shift Description and Operation (MM6)
- Special Tools and Equipment