LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission - TREMEC 6-Speed (M13 MJK Mm6 MH3)) >> Repair Instructions - Off Vehicle >> Shift Control Shaft Cover Assembly Assemble (MM6)

Shift Control Shaft Cover Assembly Assemble (MM6)

WARNING: This page is about a different variant/trim than selected.
  1. GM1825025Courtesy of GENERAL MOTORS COMPANY

    Install the shift control shaft cover seal (3).

  2. Install the shift control lever (2) and the shift control lever shaft (4).
  3. Install the shift control lever shaft pin (1).
  4. GM1825021Courtesy of GENERAL MOTORS COMPANY

    Install the shift control shaft cover set screw (1).

  5. Install the manual transmission shift lever rod universal joint assembly (3).
  6. Install the manual transmission shift lever pin (2).
  7. Install the manual transmission selector lever rod swivel retainer (4).
scientia non olet · About LEMON Manuals