Installation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE:

Before installing the shifter, ensure that the shift shaft it is clean of dirt or lubricants.

Install the shift control assembly to the transmission.
Courtesy of GENERAL MOTORS COMPANY

Install the right shift control assembly rod pin (1).
Courtesy of GENERAL MOTORS COMPANY

Install the left shift control assembly rod pin (2).

NOTE:

Note the position of the shift linkage (3) fork end. If the shift linkage fork is installed in the reversed position the transmission will not function correctly. The shift linkage fork end MUST be installed as shown.

Courtesy of GENERAL MOTORS COMPANY

Install the shift linkage assembly (3).
Install the shift linkage pin (2).
Install the shift linkage retaining clips (1).
Courtesy of GENERAL MOTORS COMPANY

Raise the transmission.

CAUTION:

Refer to Fastener Caution .

Install the 6 transmission support fasteners (1, 2), then tighten to 60 N.m (44 lb ft).
Remove the jack supporting the transmission.
Install the propeller shaft. Two-Piece Propeller Shaft Replacement (Coupe with M13, MH3, MJK, MM6) , or Two-Piece Propeller Shaft Replacement (Convertible with M13, MH3, MJK, MM6)
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Pull up and outward on the tabs on the closeout boot (1) to clear the body structure.
Courtesy of GENERAL MOTORS COMPANY

Install the 4 fasteners (1) securing the shift control assembly to the tunnel reinforcement, then tighten to 12 N.m (106 lb in).
Courtesy of GENERAL MOTORS COMPANY

Install the shift control knob (1). Transmission Control Lever Knob Replacement
Perform the gear position relearn. Gear Position Sensor Learn