Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
| Circuit |
Description |
| 5 V Reference |
Regulated voltage supplied by the control module. |
| Signal |
The control module input circuit has an internal resistance connected to ground. |
| Low Reference |
Grounded through the control module. |
| Component |
Description |
| B25B Clutch Pedal Position Sensor |
The sensor contains an analog potentiometer that varies its resistance proportionally with the position of the pedal.
- Clutch pedal not pressed = High Voltage
- Clutch pedal fully pressed = Low Voltage
|
| K20 Engine Control Module |
The control module contains a microprocessor used to process input data to control outputs. The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly. |