Filling Procedure
WARNING: This page is about a different variant/trim than selected.
Disconnect the clip (1) retaining the cooler pipe to the transmission bracket.
- Reposition the cooler pipe to allow access to the fill plug.
- Remove the transmission fluid fill plug.
-
IMPORTANT:
Transmission fluid level setting must be followed exactly as written or the transmission may be overfilled or under filled.
For fluid recommendations, Refer to Adhesives, Fluids, Lubricants, and Sealers (MJK, MH3, or MM6) .
Transmission fluid level MUST be 3.2 mm (1/8 inch) below (1) the fill plug. This can be done by one of the following two methods:
- Bend mechanics wire to 3.2 mm (1/8 inch) to check fluid level. Add or remove fluid as necessary.
- Fill transmission until level with the bottom of the fill plug hole, then remove 240 ml (8 ounces) of fluid.
- Apply sealant to the transmission fill plug (1). Adhesives, Fluids, Lubricants, and Sealers (MJK, MH3, or MM6)
- CAUTION:
Refer to Fastener Caution .
Install the transmission fill plug to the transmission and tighten the fill plug to 27 N.m (20 lb ft).
- Reconnect the clip (1) retaining the cooler pipe to the transmission bracket.
- Run the engine in Neutral for two minutes to allow the fluid to recirculate.
- Remove the fill plug and verify the fluid level is 3.2 mm (1/8 inch) below the fill plug hole. Add or remove transmission fluid as necessary.
- Install the transmission fill plug to the transmission and tighten the fill plug to 27 N.m (20 lb ft).
- Lower the vehicle.
NOTE:
Inspect the clip for proper retention on the cooler line to the bracket. Replace the clip as necessary.
NOTE:
Ensure the clutch pedal is NOT depressed.