Installation Procedure
- Clean the clutch hub and the input shaft from any debris and contaminates with a lint-free towel.
- CAUTION:
Applying too much or the wrong type of grease on the transmission input shaft may cause damage, clutch slippage or failure. Always apply the correct type of grease. Never apply more grease than is necessary to coat the transmission input shaft with a very thin film of grease.
Use a clean flat brush (1) to apply very light coating of multi-purpose grease to input shaft until the metal is only shiny. No visible clumps of grease are permissible regardless of size. Smear away from the transmission in direction of the shown arrow.
- CAUTION:
Ensure that no grease remains on the lead surface of the transmission input shaft. Clean the lead surface of the transmission input shaft prior to the assembly of the transmission to the engine. Failure to maintain a clean surface may cause clutch slippage or failure.
Clean the entire lead surface of the input shaft with a NEW, lint-free towel (1).
- With the cradle in the lowered position, fit the transmission to the vehicle. It may be necessary to push up on the front of the engine to gain enough clearance to the body structure.
- CAUTION:
Refer to Fastener Caution .
Install the two right (engine side) lower transmission clutch housing to engine fasteners (1) and tighten to 50 N.m (37 lb ft).
Install the two left lower transmission clutch housing to engine fasteners (1) and tighten to 50 N.m (37 lb ft).
Install the two right (transmission side) lower transmission clutch housing to engine fasteners (1) and tighten to 50 N.m (37 lb ft).
Install the upper transmission clutch housing to engine bolts and studs (1) and tighten to 50 N.m (37 lb ft).
Connect the lower slave cylinder hose (2) to the slave cylinder.
- Install the hydraulic clutch hose/pipe retaining clip (1) to the clutch slave cylinder.
- Connect the transmission control to the transmission. Transmission Control Replacement (M13)
- Tilt engine and transmission up and tighten all cradle bolts. Drivetrain and Front Suspension Cradle Replacement (LTG - Coupe) , or Drivetrain and Front Suspension Cradle Replacement (LTG - Convertible)
- Install the transmission mount. Transmission Rear Mount Replacement (M13 Transmission)
Install the oil pump flow control valve heat shield (4) to the engine assembly. Oil Pump Flow Control Valve Heat Shield Replacement
Install the front compartment lower noise shield (3) to the vehicle. Front Compartment Lower Noise Shield Replacement (Coupe - LGX, LTG)
Connect the following electrical connectors:
- Backup lamp switch (1)
- Vehicle speed sensor (2)
-
Courtesy of GENERAL MOTORS COMPANY
Connect the electrical connector to the transmission temperature sensor (2).
Connect the charge air cooler outlet tube (1) to the throttle body (2). Charge Air Cooler Outlet Air Tube Replacement
- Bleed to hydraulic clutch system. Hydraulic Clutch System Bleeding
- Check the transmission fluid and fill as necessary. Transmission Fluid Level Inspection (M13 Without Y4Q) , or Transmission Fluid Level Inspection (M13 With Y4Q Track Pack With or Without KNR)
Use care when cleaning the clutch hub. The clutch hub may have sharp edges and can cause personal injury if contact is made. Wear protective gloves to avoid personal injury.