LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission - TREMEC 6-Speed (M13 MJK Mm6 MH3)) >> Repair Instructions - On Vehicle >> Reverse Lockout Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4045773Courtesy of GENERAL MOTORS COMPANY

    If removed, inspect the reverse lockout assembly O-ring (3). Replace the reverse lockout assembly O-ring if necessary.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the reverse lockout assembly (4) and bolt (1) and tighten to 18 N.m (13 lb ft).
  3. Install the reverse lockout solenoid (2).

    Tighten the reverse lockout solenoid (2) to 40 N.m (30 lb ft).

  4. GM4045744Courtesy of GENERAL MOTORS COMPANY

    Connect the reverse lockout solenoid electrical connector (1).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals