LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission - TREMEC 6-Speed (M13 MJK Mm6 MH3)) >> Diagnostic Information and Procedures >> DTC P080A >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC P0651, P0806, P0807, P0808 is not set.
    • Go to next step: If the DTC is not set 
  3. Inspect the component for wear or damage: Clutch Pedal - Refer to: Symptoms - Clutch
    • If a condition exists 

      Repair or replace as necessary.

    • Go to next step: If no conditions exist 
  4. Perform the following learn procedure: Clutch Pedal Position Learn 
    • If the procedure was not successful 

      Replace the component: K20 Engine Control Module

    • Go to next step: If the procedure was successful 
  5. All OK.