LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission - TREMEC 6-Speed (M13 MJK Mm6 MH3)) >> Diagnostic Information and Procedures >> DTC P18CA >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Perform the scan tool learn/reset function: Gear Position Sensor Learn 
  3. Verify the DTC does not set.
    • If the DTC sets 

      Replace the component: K20 Engine Control Module

    • Go to next step: If the DTC does not set 
  4. All OK.
scientia non olet · About LEMON Manuals