Transmission Fluid Level Inspection (MH3, MJK, MM6)
WARNING: This page is about a different variant/trim than selected.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Base) , or Lifting and Jacking the Vehicle (ZL1) , or Lifting and Jacking the Vehicle (Convertible) .
Disconnect the clip (1) retaining the cooler pipe to the transmission bracket.
- Reposition the cooler pipe to allow access to the fill plug.
- Remove the transmission fill plug from the transmission.
-
IMPORTANT:
Transmission fluid level setting must be followed exactly as written or the transmission may be overfilled or under filled.
For fluid recommendations, Refer to Adhesives, Fluids, Lubricants, and Sealers (MJK, MH3, or MM6)
Transmission fluid level MUST be 3.2 mm (1/8 inch) below (1) the fill plug. This can be done by one of the following methods:
- Bend mechanics wire to 3.2 mm (1/8 inch) to check fluid level. Add or remove fluid as necessary.
- Fill transmission until level with the bottom of the fill plug hole, then remove 240 ml (8 ounces) of fluid.
- Install the transmission fill plug to the transmission and tighten to 27 N.m (20 lb ft).
- NOTE:
Inspect the clip for proper retention on the cooler line to the bracket. Replace the clip as necessary.
Reconnect the clip (1) retaining the cooler pipe to the transmission bracket.
- Run the engine in Neutral for two minutes to allow the fluid to recirculate.
- Remove the fill plug and verify the fluid level is 3.2 mm (1/8 inch) below the fill plug hole. Add or remove transmission fluid as necessary.
- Install the transmission fill plug to the transmission and tighten to 27 N.m (20 lb ft).
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure the clutch pedal is NOT depressed.