Conditions for Running the DTC

Condition 1 under "Setting" correlates with condition 1 under "Running"

• DTCs related to the following system/component = Not Set - {If equipped}
  • B14A Transmission Output Shaft Speed Sensor/B115 Vehicle Speed Sensor
  • B25B Clutch Pedal Position Sensor
  • B26 Crankshaft Position Sensor
  • B34 Engine Coolant Temperature Sensor
  • B75 Mass Air Flow Sensor
  • B115 Vehicle Speed Sensor
  • Q6 Camshaft Position Actuator Solenoid Valve
  • Q38 Throttle Body
• Engine Coolant Temperature = Warmer than -9°C (15°F)
• Clutch Pedal = Released

Condition 1

• Current Gear Previous Gear
• Engine Speed = Greater than 1200 RPM
• Engine Torque = Greater than 120 N.m (89 lb ft)
• Vehicle Speed = Greater than 20 km/h (12 MPH)

Frequency the DTC runs = Continuously - After the running conditions are met

Condition 2

• Engine Torque = Greater than 500 N.m (369 lb ft) - For greater than 1.2 s
• Vehicle Speed = Greater than 15 km/h (9 MPH)

Frequency the DTC runs = Continuously - After the running conditions are met

Condition 3

• Current Gear Previous Gear
• Engine Speed = Greater than 1200 RPM
• Engine Torque = Greater than 120 N.m (89 lb ft)
• Vehicle Speed = Greater than 15 km/h (9 MPH)

Frequency the DTC runs = Continuously - After the running conditions are met