LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission - TREMEC 6-Speed (M13 MJK Mm6 MH3)) >> Repair Instructions - On Vehicle >> Shift Fork Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4044865Courtesy of GENERAL MOTORS COMPANY

    Position the gear position sensor assembly (3) to the transmission.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the four gear position sensor retainers (2) and tighten to 10 N.m (89 lb in).
  3. Connect the gear position sensor electrical connector (1).
  4. Install the transmission control to the vehicle. Transmission Control Replacement (MH3, MJK, MM6) , or Transmission Control Replacement (M13) .
  5. Perform the gear position sensor learn procedure. Gear Position Sensor Learn 
scientia non olet · About LEMON Manuals