Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P0651 is not set.
- If DTC P0651 is set
- Go to next step: If DTC P0651 is not set
- Verify the component works as specified: Symptoms - Clutch
- If a condition exists
Repair or replace as necessary.
- Go to next step: If no conditions exist
- If a condition exists
- Verify the scan tool parameter: CPP Sensor = 0.2 to 4.8 V
- If not between 0.2 and 4.8 V
Refer to: Circuit/System Testing
- Go to next step: If between 0.2 and 4.8 V
- If not between 0.2 and 4.8 V
- Operate the component: Clutch Pedal
Verify the scan tool parameter: CPP Sensor = The value should not spike or drop out while moving the sensor through the entire range.
- If the value spikes or drops out
Test or replace the component: B25B Clutch Pedal Position Sensor
- Go to next step: If the value does not spike or drop out
- If the value spikes or drops out
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.