Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Component Fastener Tightening Caution .

Using the DT-49293 Gear Select/Skip Shift Solenoid Socket, install the gear select/skip shift solenoid (1) and tighten to 40 N.m (30 lb ft).
Connect the gear select/skip shift solenoid electrical connector.
Raise the rear of the transmission. Transmission Control Replacement (MH3, MJK, MM6) , or Transmission Control Replacement (M13) .
Lower the vehicle.