LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2020 >> Camaro SS, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission - TREMEC 6-Speed (M13 MJK Mm6 MH3)) >> Repair Instructions - On Vehicle >> Main Shaft Rear Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM794670Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install the seal onto the tool before installing into the case to prevent damage to the seal.

    Using J 44765  seal installer, install the new transmission case extension seal (1).

  2. GM1430041Courtesy of GENERAL MOTORS COMPANY

    Install the drive flange to the transmission output shaft.

  3. Install a NEW drive flange thrust washer.
  4. GM804354Courtesy of GENERAL MOTORS COMPANY

    Install the J 45012  holding fixture to the drive flange.

    5. CAUTION:

    Refer to Fastener Caution .

  5. While holding J 45012  holding fixture, install a NEW drive flange nut using J 29873  injector nozzle socket.

    Tighten the drive flange nut to 136 N.m (100 lb ft).

  6. Remove the J 45012  holding fixture from the drive flange.
  7. GM1236100Courtesy of GENERAL MOTORS COMPANY

    Install the propeller shaft (6). Refer to Two-Piece Propeller Shaft Replacement (Coupe with M13, MH3, MJK, MM6) , or Two-Piece Propeller Shaft Replacement (Convertible with M13, MH3, MJK, MM6)

  8. Lower the vehicle.
scientia non olet · About LEMON Manuals