Section 70 (Seats - Removal, Replacement And Installation (Coupe))
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Front Seat (1998)
- Mechanical Front Seats (1999-2002)
- Backrest adjustment knob
- Backrest cable
- Backrest fold-down handle
- Backrest fold-down mechanism assembly
- Backrest mounting
- Backrest padding
- Backrest upholstery
- Cable and spring, fittings
- Cables for folding down the seat and moving it forward
- End mounting / Slide rail
- Front seat belt buckle
- Head restraint sleeves
- Lifting mechanical seats in and out
- Lumbar support
- Lumber support adjustment knob, replacing
- Lumber support strap
- Protective pad
- Replacing heating pads
- Notes
- Preparations
- General information about different types of heater pads
- General information about foam filling
- Foam filling with only front-rear channels
- Foam filling with front-rear channels and one lateral channel
- Foam filling with front-rear channels, one lateral channel and a design channel
- Foam filling with front-rear channels, two lateral channels and a design channel
- Foam filling with linked front-rear channels, two lateral channels and a design channel
- Replacing heating pads
- Installing heater pads
- Replacing seat rails / mounting stays
- Replacing the front seat head restraints
- Seat cushion padding
- Seat cushion upholstery
- Side panel
- SIPS airbag
- SRS connector
- The tilt mechanism
- Whips
- Noise (1999-2002)
- Other Interior Trim (1998-2002)
- Power Front Seats (1999-2002)
- Backrest cable
- Backrest fold-down handle
- Backrest fold-down mechanism assembly
- Backrest mounting
- Backrest padding
- Backrest upholstery
- Cable and spring, fittings
- Connector
- Control module
- Control panel
- Cross stay
- End mounting / Slide rail
- Front height adjustment motor (front motor)
- Front seat belt buckle
- Front-rear adjustment motor (center motor)
- Head restraint sleeves
- Lifting the power seat in and out
- Lumbar support
- Lumber support adjustment knob, replacing
- Lumber support strap
- Making power supply wiring
- Micro-switches
- Potentiometer for the front height adjustment motor
- Potentiometer for the rear height adjustment motor
- Power seat gear
- Protective pad
- Rear height adjustment motor (rear motor)
- Replacing heating pads
- Notes
- Preparations
- General information about different types of heater pads
- General information about foam filling
- Foam filling with only front-rear channels
- Foam filling with front-rear channels and one lateral channel
- Foam filling with front-rear channels, one lateral channel and a design channel
- Foam filling with front-rear channels, two lateral channels and a design channel
- Foam filling with linked front-rear channels, two lateral channels and a design channel
- Replacing heating pads
- Installing heater pads
- Replacing the backrest motor and potentiometer
- Replacing the front seat head restraints
- Replacing WHIPS
- Seat cushion padding
- Seat cushion upholstery
- Seat rail
- Side panel
- SIPS airbag
- SRS connector
- The potentiometer and shaft for the front-rear adjustment motor
- The tilt mechanism
- Power Seat (1999-2000)
- Programming Entry Position (1998-2002)
- Replacing Motors And Switches (1998)
- Replacing Motors And Switches (1999-2000)
- Sun Visor With Light And/Or HOMELINK (1999-2002)