Programming using the Volvo Scan Tool (ST)

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Volvo Scan Tool

Courtesy of VOLVO CARS OF NORTH AMERICA.

Disconnect the Volvo Scan Tool (ST) from the VIDA-station. Connect the Volvo Scan Tool (ST) to the data link connector (DLC) as a stand alone tool. See Connecting the Volvo System Tester
Start the Volvo Scan Tool (ST). Select language, model, bodywork and seat
Select "Entry position".
Press "Enter".

Completion

The preset entry position is now programmed into the control module.

Switch off the Volvo Scan Tool (ST) and disconnect it from the car.