Programming entry position

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Power Seat Switches And Backrest Lever

Courtesy of VOLVO CARS OF NORTH AMERICA.

Adjust the front-rear position of the seat to the most forward position using the control button.
Move the seat backward approximately 5 mm.
Press the MEM button (4) and hold down (otherwise the seat moves forward with the following command).
Fold the backrest forward using the handle (5). Hold the handle up.
Press the MEM buttons 1, 2 and 3 at the same time (1, 2 and 3).

NOTE:

Do not release the fold handle and other buttons.

Wait at least 5 seconds.

Conclusion

The preset entry position is now programmed into the control module.