Section 76 (Engine Mechanical)
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Precautions
- Notes
- Precautions When Using Power Tools (Air Or Electric) And Hammers
- Precaution For Draining Coolant
- Precaution For Disconnecting Fuel Piping
- Precaution For Removal And Disassembly
- Precaution For Inspection, Repair And Replacement
- Precaution For Assembly And Installation
- Special Cautions To Ensure The Safe Disposal Of Sodium-Filled Valves
- Parts Requiring Angular Tightening
- Precaution For Liquid Gasket
- Preparation
- System Description
- Periodic Maintenance
- Removal And Installation
- Engine Room Cover
- Air Cleaner And Air Duct
- Intake Manifold Collector
- Intake Manifold
- Exhaust Manifold And Three Way Catalyst
- Three Way Catalyst
- Oil Pan And Oil Strainer
- Ignition Coil
- Fuel Injector And Fuel Tube
- Rocker Cover
- Valve Timing Control
- Front Timing Chain Case
- Timing Chain
- Rear Timing Chain Case
- Camshaft
- Oil Seal
- Cylinder Head
- Engine Mount
- Unit Removal And Installation
- Unit Disassembly And Assembly
- Cylinder Block
- Exploded View
- Disassembly and Assembly
- Inspection
- Piston And Piston Pin Clearance
- Piston Ring Side Clearance
- Piston Ring End Gap
- Connecting Rod Bend And Torsion
- Connecting Rod Bearing Housing Diameter (Big End)
- Connecting Rod Bushing Oil Clearance (Small End)
- Cylinder Block Distortion
- Inner Diameter Of Main Bearing Housing
- Piston-To-Cylinder Bore Clearance
- Crankshaft
- Bearing Clearance
- Drive Plate RUNOUT
- Oil Jet
- Oil Jet Relief Valve
- Dowel Pin Alignment
- Cylinder Block
- Service Data And Specifications (SDS)