LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Mechanical) >> Removal And Installation >> Rocker Cover >> Removal and Installation (RH) >> Removal

Removal and Installation (RH): Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine room cover. Refer to Removal and Installation .
  2. Remove the front air duct and air duct hose and resonator assembly. Refer to Removal and Installation .
  3. Remove the intake manifold collector. Refer to Removal and Installation .
  4. Remove ignition coils. Refer to Removal and Installation (RH) .
    CAUTION: Do not shock ignition coils.
  5. Remove camshaft position sensors.
    GNSALBIA0258Z-258Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Handle carefully to avoid dropping and shocks.
    • Do not disassemble.
    • Do not allow metal powder to cling to magnetic part at sensor tip (A).
    • Do not place sensors in a location where they are exposed to magnetism.
  6. Remove RH rocker cover bolts from cylinder head in the reverse order as shown, below.
    Fig 1: Rocker Cover Bolt Tightening Sequence
    GNSAWBIA0705Z-705Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Engine front
  7. Remove the rocker cover and gasket.
scientia non olet · About LEMON Manuals