LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Mechanical) >> Removal And Installation >> Engine Mount >> Engine Mount (Rear) >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative terminal. Refer to Battery Disconnect .
  2. Remove cowl top extension. Refer to Removal and Installation .
  3. Remove the air cleaner and air duct. Refer to Removal and Installation .
  4. Remove the strut brace.
  5. Remove engine room cover. Refer to Removal and Installation .
  6. Remove the air cleaner assembly. Refer to Removal and Installation .
  7. Remove the engine under cover. Refer to Removal and Installation .
  8. Remove the tire and wheel. Refer to Removal and Installation .
  9. Use a suitable jack (A) to securely support the bottom of the engine (1) and the transaxle assembly (2).
    G08432175Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Put a piece of wood or an equivalent as the supporting surface and secure in a stable condition.
  10. Disconnect the brake booster vacuum hose.
  11. Disconnect the RH sway bar link from the front strut.
  12. Remove the RH front drive shaft assembly. Refer to Removal and Installation (RH) .
  13. Remove front exhaust tube. Refer to Exploded View .
  14. Disconnect the air/fuel ratio sensor electrical connector.
  15. Remove the LH TWC heat shield.
  16. Disconnect the VIAS control solenoid electrical connector.
  17. Disconnect the following:
    • Vacuum hose at the power valve.
    • Vacuum hose at the intake collector.
    • EVAP vacuum hose.
  18. Disconnect the EVAP canister purge control solenoid electrical connector, then remove the EVAP canister purge control solenoid.
  19. Disconnect the throttle actuator electrical connector, then set the throttle body aside. Discard the gasket.
  20. Disconnect the PCV breather hose.
  21. Remove the intake manifold collector. Refer to Removal and Installation .
  22. Remove the engine mount insulator nut (A).
    G08432176Courtesy of NISSAN NORTH AMERICA, INC.
  23. Loosen the engine mount bracket bolts in the reverse order shown, below.
    Fig 1: Engine Mount Bracket Bolt Tightening Sequence
    GNSAWBIA1834Z-834Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Engine front
  24. Remove the engine mount bracket.
  25. Remove the engine mount insulator bolts in the reverse order as shown, below.
    Fig 2: Engine Mount Insulator Bolt Tightening Sequence
    GNSAWBIA1833Z-833Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Vehicle front
  26. Remove the engine mount insulator.
    NOTE: Raise or lower engine and transaxle assembly as required with shop crane.
    G08432179Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals