Removal and Installation: Notes

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Place chocks at front and back of rear wheels.

For engines not equipped with engine slingers, attach proper slingers and bolts as described in the NISSAN Parts Catalog.

CAUTION:

Do not start working until exhaust system and coolant are cool.
If items or work required are not covered by the engine main body article, follow the applicable procedures.
Use the correct supporting points for lifting and jacking. Refer to Garage Jack and Safety Stand and 2-Pole Lift .
In removing the drive shafts, be careful not to damage any transaxle grease seals.
Before separating the engine and transaxle, remove the crankshaft position sensor (POS). Refer to Exploded View .
Do not damage the edge of the crankshaft position sensor (POS) or the ring gear teeth.

NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.