LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Mechanical) >> Removal And Installation >> Engine Mount >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount insulator (front).
    G08432179Courtesy of NISSAN NORTH AMERICA, INC.
  2. Install the engine mount insulator (front) bolts and tighten to specification in the order shown.
    GNSJPBIA1735Z-735Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Front

    Engine mount insulator (front) bolts

    : 43 N.m (4.4 kg-m, 32 ft-lb)
    CAUTION: Check engine mount insulator (front) is seated properly before tightening.
  3. Install the engine mount bracket (front) to the engine block.
  4. Tighten the engine mount bracket (front) bolts to specification in the order shown.
    GNSJPBIA1731Z-731Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Engine front

    Engine mount bracket (front) bolts

    : 40 N.m (4.1 kg-m, 30 ft-lb)
  5. Install the engine mount insulator (front) nut (A) and tighten to specification.
    G08432176Courtesy of NISSAN NORTH AMERICA, INC.

    Engine mount insulator (front) nut

    : 103 N.m (11 kg-m, 76 ft-lb)
  6. Installation of the remaining components is in the reverse order of removal.
scientia non olet · About LEMON Manuals