Removal and Installation (RH): Installation

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION: Do not reuse gaskets.

Apply sealant to the areas on the front corners using a suitable tool.

Courtesy of NISSAN NORTH AMERICA, INC.
Use Genuine Silicone RTV Sealant or equivalent. Refer to Recommended Chemical Products and Sealants .
CAUTION:
- Installation should be done within 5 minutes after applying liquid gasket.
- Do not fill the engine with oil for at least 30 minutes after the components are installed to allow the sealant to cure.

Tighten the rocker cover bolts in two steps in the order shown.

Courtesy of NISSAN NORTH AMERICA, INC.

: Engine front

Rocker cover bolts
Step 1	: 1.96 N.m (0.20 kg-m, 17 in-lb)
Step 2	: 8.33 N.m (0.85 kg-m, 74 in-lb)