LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Mechanical) >> Removal And Installation >> Engine Mount >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly, front air duct, and air duct hose and resonator tube assembly. Refer to Removal and Installation .
  2. Remove the battery. Refer to Removal and Installation (Battery) .
  3. Remove the battery tray assembly. Refer to Removal and Installation (Battery Tray) .
  4. Remove the transmission control module (TCM). Refer to Removal and Installation .
  5. Remove the engine control module (ECM). Refer to Removal and Installation .
  6. Disconnect the harness from the ECM and TCM bracket, then remove the ECM and TCM bracket.
  7. Remove the coolant from the radiator. Refer to Changing Engine Coolant .
  8. Remove the upper radiator hose.
  9. Remove the inlet heater pipe (lower)
  10. Remove the fan shroud and motor assembly. Refer to Removal and Installation .
  11. Remove the exhaust manifold heat shield (bank 2). Refer to Removal and Installation (bank 2) .
  12. Support the engine (1) and transaxle (2) using a suitable jack (A) as shown, below.
    G08432175Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Position a suitable jack under the engine and transaxle assembly as shown, above.
    • Do not damage the front exhaust tube or transaxle oil pan with the jack.
  13. Disconnect the air/fuel ratio sensor electrical connector.
  14. Disconnect the engine mount insulator (front) vacuum hose.
  15. Remove the engine mount insulator (front) nut (A).
    G08432176Courtesy of NISSAN NORTH AMERICA, INC.
  16. Loosen the engine mount bracket (front) bolts in the reverse order shown.
    GNSJPBIA1731Z-731Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Engine front
  17. Remove the engine mount bracket (front).
  18. Remove the engine mount insulator (front) bolts in the reverse order as shown, below.
    Fig 1: Engine Mount Insulator (Front) Bolt Tightening Sequence
    GNSJPBIA1735Z-735Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Vehicle front
  19. Remove the engine mount insulator (front).
    G08432179Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals