LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Mechanical) >> Removal And Installation >> Valve Timing Control >> Valve Timing Control Cover (bank 1) >> Removal

Valve Timing Control Cover (bank 1): Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect battery negative terminal. Refer to Battery Disconnect .
  2. Remove core support cover. Refer to Exploded View .
  3. Remove front air duct. Refer to Removal and Installation .
  4. Remove cowl top and cowl top extension. Refer to Removal and Installation .
  5. Remove coolant reservoir tank. Refer to Exploded View .
  6. Remove power steering oil pump. Refer to Removal and Installation .
  7. Support engine (1) and transaxle (2) using suitable jack (A).
    G08432175Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Position a suitable jack under the engine and transaxle assembly as shown, above.
    • Do not damage the front exhaust tube or transaxle oil pan with the jack.
  8. Remove upper torque rod, engine mounting insulator (RH), and engine mounting bracket (RH). Refer to Removal and Installation .
  9. Disconnect intake valve timing intermediate lock control solenoid valve (bank 1) harness connector.
  10. Disconnect exhaust valve timing control solenoid valve (bank 1) harness connector.
  11. Disconnect intake valve timing control solenoid valve (bank 1) harness connector.
  12. Remove intake valve timing intermediate lock control solenoid valve (bank 1), exhaust valve timing control solenoid valve (bank 1), and intake valve timing control solenoid valve (bank 1) from valve timing control cover (bank 1).
    CAUTION: Do not reuse O-rings.
  13. Remove valve timing control cover (bank 1).
scientia non olet · About LEMON Manuals