Removal and Installation (bank 2): Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Perform the work when the exhaust system has completely cooled down.
When removing the front and rear engine mounting through bolts and nuts, lift the engine up slightly for safety.

NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

Remove the radiator. Refer to Removal and Installation .
Remove the three way catalyst. Refer to Removal and Installation (bank 2) .
Loosen and remove the exhaust manifold nuts in the reverse order as shown, below.

Fig 1: Bank 2 Exhaust Manifold Nut Tightening Sequence
Courtesy of NISSAN NORTH AMERICA, INC.

: Engine front

NOTE: Number 7 and 8 are not applicable to removal.
Remove the exhaust manifold (bank 2) and gasket.