Section 53 (Engine Overhaul - 3.0L)
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- General Specifications
- Service Specifications
- Processing Standard Value
- Fastener Tightening Specifications
- Sealants And Adhesives
- Special Tools
- Generator And Drive Belt
- Intake Manifold Plenum And Throttle Body Assembly
- Timing Belt
- Intake Manifold
- Water Hose And Pipe
- Removal And Installation
- Notes
- Installation Service Points
- >> A << Engine Oil Control Valve Housing Installation
- >> B << Engine Oil Pressure Switch Installation
- >> C << Engine Oil Control Valve Installation
- >> D << Water Pipe/O-Ring Installation
- >> E << Thermostat Housing Gasket Installation
- >> F << Thermostat Installation
- >> G << Oil Pipe Installation
- >> H << Exhaust Gas RECIRCULATION Valve Gasket Installation
- >> I << Engine Coolant Temperature Sensor Installation
- Removal And Installation
- Exhaust Manifold
- Rocker Cover And Camshaft
- Removal And Installation
- Notes
- Removal Service Point
- Installation Service Points
- >> A << Camshaft, Right/Camshaft, Left Installation
- >> B << Camshaft Position Sensing Cylinder Installation
- >> C << Lash Adjuster Installation
- >> D << Adjusting Screw Installation
- >> E << Rocker Arms And Shaft/Rocker Shaft Cap Installation
- >> F << Camshaft Oil Seal Installation
- >> G << Rocker Cover, Right/Rocker Cover, Left Installation
- Inspection
- Removal And Installation
- Cylinder Head And Valves
- Oil Pan And Oil Pump
- Removal And Installation
- Notes
- Removal Service Points
- Installation Service Points
- >> A << Oil Pump Case Installation
- >> B << Crankshaft Front Oil Seal Installation
- >> C << Beam/Bearing Cap Bolt/Right Plate/Left Plate Installation
- >> D << Oil Screen Gasket Installation
- >> E << Oil Pan Upper Installation
- >> F << Oil Pan Lower Installation
- >> G << Engine Oil Pressure Switch Installation
- >> H << Oil Filter Cover Installation
- >> I << Oil Filter Installation
- >> J << Drain Plug Gasket Installation
- Removal And Installation
- Piston And Connecting Rod
- Crankshaft And Cylinder Block
- Removal And Installation
- Notes
- Removal Service Point
- Installation Service Points
- >> A << Crankshaft Sensing Ring Installation
- >> B << Crankshaft Bearing Upper Installation
- >> C << Crankshaft Thrust Bearing Installation
- >> D << Crankshaft Bearing Lower Installation
- >> E << Bearing Cap/Bearing Cap Bolt Installation
- >> F << Crankshaft Rear Oil Seal Installation
- >> G << Oil Seal Case Installation
- >> H << Drive Plate Bolt Installation
- Cylinder Block Inspection
- Removal And Installation