LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Overhaul - 3.0L) >> Intake Manifold Plenum And Throttle Body Assembly >> Removal And Installation >> Installation Service Point >> >> B << Intake Manifold Plenum Stay, Front Installation

>> B << Intake Manifold Plenum Stay, Front Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. After temporarily tightening the front manifold plenum stay with the installation bolts, check that the intake manifold fastens securely to the cylinder head.
  2. Tighten the front manifold plenum stay to the specified torque.

    Tightening torque: 23 ± 6 N.m (17 ± 4 ft-lb). 

    Fig 1: Identifying Intake Manifold Plenum Stay, Front
    G09663769
scientia non olet · About LEMON Manuals