LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Overhaul - 3.0L) >> Water Hose And Pipe >> Removal And Installation >> Installation Service Points >> >> A << Engine Oil Control Valve Housing Installation

>> A << Engine Oil Control Valve Housing Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Oil passage shall be free from foreign matters.
  • Shall confirm fully that matching plane and such are free from foreign matters.
  1. Install the engine oil control valve housing gasket and oil seal case gasket so that the protuberant is positioned as shown in the illustration.
  2. Tighten the engine oil control valve housing and oil seal case to the specified torque.

    Tightening torque: 24 ± 3 N.m (18 ± 2 ft-lb) 

    Fig 1: Identifying Engine Oil Control Valve Housing Gasket And Oil Seal Case Gasket
    G09663805
scientia non olet · About LEMON Manuals