>> C << Engine Oil Control Valve Installation
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Never re-use the O-ring.
- Before installing O-ring, wind sealing tape around the oil passages cut-out area of engine oil control valve, to prevent damage. If the O-ring is damaged, it can cause an oil leak.
- Apply a small amount of engine oil to the O-ring and then install it to the engine oil control valve.
- Install the engine oil control valve to the cylinder head.
- Tighten the engine oil control valve.
Tightening torque: 11 ± 1 N.m (97 ± 8 in-lb)