LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Overhaul - 3.0L) >> Crankshaft And Cylinder Block >> Removal And Installation >> Installation Service Points >> >> H << Drive Plate Bolt Installation

>> H << Drive Plate Bolt Installation

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Cleanly remove sealant, oil and dust on the drive plate bolt, the drive plate and the threaded portions of the crankshaft.
  2. Apply oil to the drive plate and the seating surface of the drive plate bolt.
  3. Apply oil to the threaded hole of the crankshaft
  4. Apply sealant (Three bond 1324 or equivalent) to the thread portions of the drive plate bolt.
    Fig 1: Identifying Sealant Applying Area On Drive Plate Bolt
    G09663922
  5. Using special tool MD998781, hold the drive plate.
  6. Tighten the drive plate bolt to the specified torque.

    Tightening torque: 76 ± 4 N.m (56 ± 2 ft-lb) 

    Fig 2: Holding Drive Plate Using Special Tool MD998781
    G09663923
scientia non olet · About LEMON Manuals