Section 8 (19 - Engine - Cooling 2.9L Turbo Hybrid -- 971 - PANAMERA (971))

WARNING: This page is about a different variant/trim than selected.

WM, 190101 Checking Cooling System
- Tools
- Preliminary Work
- Checking Cooling System
- Subsequent Work
WM, 190107 Bleeding The Cooling System
- Preliminary Work
- Bleeding The Cooling System Manually
- Bleeding The Cooling System Using PIWIS Tester
  - Bleeding The Cooling System
- Subsequent Work
WM, 190129 Cleaning The Cooling System
- Preliminary Work
- Cleaning The Cooling System
- Subsequent Work
WM, 190819 Removing And Installing Electric Fan
- Information
WM, 191419 Removing And Installing Temperature Sensor For Fan (V6 Turbo)
- Technical Values
- Preliminary Work
- Removing And Installing Temperature Sensor For Fan
- Subsequent Work
WM, 192019 Removing And Installing Cooling Fan Housing (Radiator Frame)
- Technical Values
- Preliminary Work
- Removing Cooling Fan Housing (Radiator Frame)
- Installing Cooling Fan Housing (Radiator Frame)
- Subsequent Work
WM, 192419 Removing And Installing Front Air Guide
- Preliminary Work
- Removing Front Air Guide
- Installing Front Air Guide
- Subsequent Work
WM, 192419 Removing And Installing Front Air Guide (Cooling-Air Flaps)
- Preliminary Work
- Removing Front Air Guide (Cooling-Air Flaps)
- Installing Front Air Guide (Cooling-Air Flaps)
- Subsequent Work
WM, 192919 Removing And Installing Thermal Management Control Unit
- Preliminary Work
- Removing Thermal Management Control Unit
- Installing Thermal Management Control Unit
- Subsequent Work
WM, 192955 Replacing Thermal Management Control Unit
- Technical Values
- Replacing Thermal Management Control Unit
WM, 193219 Removing And Installing Motor For Cooling-Air Flaps
- Preliminary Work
- Removing Motor For Cooling-Air Flaps
- Installing Motor For Cooling-Air Flaps
- Subsequent Work
WM, 193519 Removing And Installing Cooling-Air Flaps
- Preliminary Work
- Removing Cooling-Air Flaps
- Installing Cooling-Air Flaps
- Subsequent Work
WM, 193817 Draining And Filling Coolant
- Tools
- Tools And Materials
  - Filling Device - Overview And Setup
- Preliminary Work
- Draining Coolant
- Filling Coolant
- Subsequent Work
WM, 193817 Drain And Fill Coolant (Low-Temperature Cooling System)
- Tools
- Preliminary Work
- Draining Coolant
- Refilling Coolant
- Bleeding The Cooling System
- Checking The Cooling System For Leaks
- Subsequent Work
WM, 194019 Removing And Installing Coolant Reservoir (Low-Temperature System)
- Tools
- Technical Values
- Preliminary Work
- Removing Coolant Reservoir
- Installing Coolant Reservoir
- Subsequent Work
WM, 194019 Removing And Installing Coolant Reservoir
- Tools
- Technical Values
- Preliminary Work
- Removing Coolant Reservoir
- Installing Coolant Reservoir
- Subsequent Work
WM, 194519 Removing And Installing Additional Coolant Pump For Low-Temperature System (P1, P2) (Hybrid)
- Tools
- Technical Values
- Preliminary Work
  - Preliminary Work - Additional Coolant Pump For Low-Temperature System (P1)
  - Preliminary Work - Additional Coolant Pump For Low-Temperature System (P2)
- Removing Additional Coolant Pump For Low-Temperature System
  - Removing Additional Coolant Pump For Low-Temperature System (P1)
  - Removing Additional Coolant Pump For Low-Temperature System (P2)
- Installing Additional Coolant Pump For Low-Temperature System
  - Installing Additional Coolant Pump For Low-Temperature System (P1)
  - Installing Additional Coolant Pump For Low-Temperature System (P2)
- Subsequent Work
  - Subsequent Work - Additional Coolant Pump For Low-Temperature System (P1)
  - Subsequent Work - Additional Coolant Pump For Low-Temperature System (P2)
WM, 194519 Removing And Installing Additional Coolant Pump (Run-On) (V6 Turbo)
- Tools
- Technical Values
  - Notes
  - Preliminary Work
- Removing Additional Coolant Pump
- Installing Additional Coolant Pump
- Subsequent Work
WM, 194519 Removing And Installing Additional Coolant Pump For High-Temperature System (P5) (Hybrid)
- Tools
- Technical Values
- Preliminary Work
- Removing Additional Coolant Pump For High-Temperature System (P5)
- Installing Additional Coolant Pump For High-Temperature System (P5)
- Subsequent Work
WM, 195019 Removing And Installing Coolant Pump (V6 Turbo)
- Tools
- Technical Values
- Preliminary Work
- Removing Coolant Pump
- Installing Coolant Pump
- Concluding Work
  - Subsequent Work
WM, 195819 Removing And Installing Coolant Regulator (Thermostat Insert) (V6 Turbo)
- Tools
- Technical Values
- Component Information
  - Installation Position Of Coolant Regulator (Thermostat Insert)
- Preliminary Work
- Removing Coolant Regulator (Thermostat Insert)
- Installing Coolant Regulator (Thermostat Insert)
- Subsequent Work
WM, 196819 Removing And Installing Directional-Control Valve For High-Temperature System (WMV 1)
- Tools
- Technical Values
- Preliminary Work
- Removing Directional-Control Valve For High-Temperature System (WMV 1)
- Installing Directional-Control Valve For High-Temperature System (WMV 1)
- Subsequent Work
WM, 196919 Removing And Installing Control Valve (V6 Turbo)
- Technical Values
- Preliminary Work
- Removing Control Valve
- Installing Control Valve
- Subsequent Work
WM, 197019 Removing And Installing Radiator
- Tools
- Technical Values
- Preliminary Work
- Removing Radiator
- Installing Radiator
- Subsequent Work
WM, 197019 Removing And Installing Radiator For Low-Temperature System
- Preliminary Work
- Removing Radiator For Low-Temperature System
- Installing Radiator For Low-Temperature System
- Subsequent Work
WM, 197119 Removing And Installing Change-Over Valve For Low-Temperature System (UVW 1)
- Tools
- Technical Values
- Preliminary Work
- Removing Change-Over Valve For Low-Temperature System
- Installing Change-Over Valve For Low-Temperature System
- Subsequent Work
WM, 197119 Removing And Installing Change-Over Valve For High-Temperature System (UVW 3) (Hybrid)
- Tools
- Technical Values
- Preliminary Work
- Removing Change-Over Valve For High-Temperature System (UVW 3)
- Installing Change-Over Valve For High-Temperature System (UVW 3)
- Subsequent Work
WM, 197319 Removing And Installing Heat EXCHANGER For High-Temperature And Low-Temperature System
- Tools
- Technical Values
- Preliminary Work
- Removing Heat EXCHANGER For High-Temperature And Low-Temperature System
- Installing Heat EXCHANGER For High-Temperature And Low-Temperature System
- Subsequent Work
WM, 197819 Removing And Installing Coolant Temperature Sensor (Engine Outlet) (V6 BITURBO)
- Technical Values
- Component Information
  - Installation Position Of Coolant Temperature Sensor (Engine Outlet)
- Preliminary Work
- Removing Coolant Temperature Sensor (Engine Outlet)
- Installing Coolant Temperature Sensor
- Subsequent Work
WM, 197819 Removing And Installing Coolant Temperature Sensor (Radiator Outlet)
- Technical Values
- Component Information
  - Installation Position Of Coolant Temperature Sensor (Radiator Outlet)
- Preliminary Work
- Removing Coolant Temperature Sensor (Radiator Outlet)
- Installing Coolant Temperature Sensor (Radiator Outlet)
- Subsequent Work
WM, 197819 Removing And Installing Coolant Temperature Sensor (Cylinder Head) (V6 BITURBO)
- Technical Values
- Installation Position
  - Installation Position Of Coolant Temperature Sensor
- Preliminary Work
- Removing Coolant Temperature Sensor
- Installing Coolant Temperature Sensor
- Subsequent Work
WM, 197819 Removing And Installing Coolant Temperature Sensor (Engine Temperature Control) (V6 BITURBO)
- Technical Values
- Component Information
  - Installation Position Of Coolant Temperature Sensor (Cylinder Housing)
- Preliminary Work
- Removing Coolant Temperature Sensor (Cylinder Housing)
- Installing Coolant Temperature Sensor (Cylinder Housing)
- Subsequent Work
WM, 197819 Removing And Installing High-Temperature Circuit Temperature Sensor (TW 12)
- Preliminary Work
- Removing High-Temperature Circuit Temperature Sensor
- Installing High-Temperature Circuit Temperature Sensor
- Subsequent Work
WM, 197819 Removing And Installing Low-Temperature Circuit Temperature Sensor (TW 8)
- Preliminary Work
- Removing Low-Temperature Circuit Temperature Sensor
- Installing Low-Temperature Circuit Temperature Sensor
- Subsequent Work
WM, 197819 Removing And Installing Low-Temperature Circuit Temperature Sensor (TW 6)
- Preliminary Work
- Removing Low-Temperature Circuit Temperature Sensor
- Installing Low-Temperature Circuit Temperature Sensor
- Subsequent Work
WM, 197819 Removing And Installing High-Temperature Circuit Temperature Sensor (TW 11)
- Preliminary Work
- Removing High-Temperature Circuit Temperature Sensor
- Installing High-Temperature Circuit Temperature Sensor
- Subsequent Work
WM, 197819 Removing And Installing Low-Temperature Circuit Temperature Sensor (TW 7)
- Technical Values
- Preliminary Work
- Removing Low-Temperature Circuit Temperature Sensor (TW 7)
- Installing Low-Temperature Circuit Temperature Sensor (TW 7)
- Subsequent Work
WM, 197819 Removing And Installing Low-Temperature Circuit Temperature Sensor (TW 10)
- Technical Values
- Preliminary Work
- Removing Low-Temperature Circuit Temperature Sensor
- Installing Low-Temperature Circuit Temperature Sensor
- Subsequent Work
WM, 199219 Removing And Installing Temperature Sensor For Supply Line
- Technical Values
- Installation Position
- Preliminary Work
- Removing Temperature Sensor For Supply Line
- Installing Temperature Sensor For Supply Line
- Subsequent Work
WM, 199319 Removing And Installing Temperature Sensor For Return Line
- Technical Values
- Installation Position
- Preliminary Work
- Removing Temperature Sensor For Return Line
- Installing Temperature Sensor For Return Line
- Subsequent Work