LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (19 - Engine - Cooling 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 192019 Removing And Installing Cooling Fan Housing (Radiator Frame) >> Removing Cooling Fan Housing (Radiator Frame)

Removing Cooling Fan Housing (Radiator Frame)

WARNING: This page is about a different variant/trim than selected.
WARNING: Electrically moved components 
  • Danger of limbs being trapped or severed 

    → Switch off electric power to drive motor.

    → Make sure it does not switch on again.

    → Check that there is no electric charge.

  1. Disconnect electric line for the cover latch at the cooling fan housing.
  2. Release and disconnect electric plug connection for electric fan -1-  .
    G15823161Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Electric plug connection

  3. Unclip electric plug connection -2-  from cooling fan housing (radiator frame) -3-  .
    G15823162Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Electric plug connection

  4. Remove expansion rivets -1-  from air guide on cooling fan housing (radiator frame) -2-  .
    G15823163Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Expanding rivets

  5. Disengage lower air guide -1-  from cooling fan housing (radiator frame) -Arrow-  and move it towards the engine.
    G15823164Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Air guide

  6. Unscrew screws -1-  on cooling fan housing (radiator frame) -2-  and release the tab at the left and right -Arrow-  .
    G15823165Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Cooling fan housing (radiator frame)

  7. Guide out cooling fan housing (radiator frame) -2-  by moving it downwards.
G15823166Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cooling fan housing (radiator frame)

scientia non olet · About LEMON Manuals