LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (19 - Engine - Cooling 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 194519 Removing And Installing Additional Coolant Pump For Low-Temperature System (P1, P2) (Hybrid) >> Installing Additional Coolant Pump For Low-Temperature System >> Installing Additional Coolant Pump For Low-Temperature System (P2)

Installing Additional Coolant Pump For Low-Temperature System (P2)

WARNING: This page is about a different variant/trim than selected.
  1. Install additional coolant pump for low-temperature system -1-  .
    1. 1.1 Insert additional coolant pump for low-temperature system -1-  into holder -6-  .
    2. 1.2 Close holder -6-  and fit and tighten screw -5-  .

      > Tightening torque 8 Nm (6 ftlb.) 

    3. 1.3 Connect and lock cable plug -4-  .
    4. 1.4 Push on coolant hoses -3-  and tighten spring band clamps -2-  using > VAS 6890 - Spring Band Clamp Pliers  .
      G15823250Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Additional coolant pump for low-temperature system (P2)

  2. Secure holder -1-  .
    1. 2.1 Move holder -1-  into installation position.
    2. 2.2 Screw on nut -2-  and screw in screws -3-  .
    3. 2.3 Tighten screws -3-  .

      > Tightening torque 8 Nm (6 ftlb.) 

    4. 2.4 Tighten nut -2-  .

      > Tightening torque 6 Nm (4.5 ftlb.) 

      G15823251Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Bracket

scientia non olet · About LEMON Manuals