Section 31 (Manual A/C-Heater Systems - HVAC)
WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description & Operation
- Refrigerant System Service Warnings
- Troubleshooting Index
- Refrigerant System Tests
- Refrigerant Oil Addition
- Inspection And Assembly Requirements - Following Compressor Failure
- Refrigerant System Filtering After A/C Compressor Replacement
- Spring Lock Coupling
- Peanut Fitting
- Service Gauge Port Valves
- A/C Compressor Pressure Relief Valve
- A/C Compressor Inspection
- A/C Evaporator/Condenser Core - On-Vehicle Leak Test
- Magnetic Clutch Adjustment
- A/C Condenser Core Description 196
- A/C Pressure Cut-Off Switch Description
- Receiver/Drier Description
- System Tests
- Pinpoint Test 1: Improper/Erratic Direction Of Air Flow From Outlet(S)
- Pinpoint Test 2: Insufficient, Erratic Or No Heat
- Pinpoint Test 3: The A/C Does Not Operate/Does Not Operate Properly
- Pinpoint Test 4: The A/C Is Always On
- Pinpoint Test 5: Insufficient A/C Cooling
- Pinpoint Test 6: No Operation In All Temperature Settings
- Pinpoint Test 7: The Blower Motor Does Not Operate
- Pinpoint Test 8: The Blower Motor Operates Continuously In High Speed
- Pinpoint Test 9: No Operation In High Blower Setting
- Pinpoint Test 10: No Operation In Lower Speeds
- Component Tests
- Removal & Installation
- Notes
- Receiver/Drier Removal/Installation
- Condenser Core Removal/Installation
- Shaft Seal Removal/Installation
- Magnetic Clutch Removal/Installation
- Compressor
- A/C Compressor Bracket Removal/Installation (3.0L)
- A/C Compressor Bracket Removal/Installation (4.0L)
- Evaporator Core Orifice Removal/Installation
- Evaporator Core Housing Removal/Installation
- Evaporator Core Removal/Installation
- LH Instrument Panel Register Removal/Installation
- LH Instrument Panel Register Duct Removal/Installation
- RH Instrument Panel Register Removal/Installation
- RH Instrument Panel Register Duct Removal/Installation
- Center Instrument Panel Register Removal/Installation
- Center Instrument Panel Duct Register Removal/Installation
- Windshield Defroster And Side Window Demister Nozzles Removal/Installation
- Air Inlet Duct Door Removal/Installation
- Heater Outlet Floor Duct Removal/Installation
- Plenum Chamber Removal/Installation
- Heater Hose Removal/Installation
- Heater Core Removal/Installation
- Manifold And Tube Assembly Removal/Installation (2.3L)
- Manifold And Tube Assembly Removal/Installation (3.0L)
- Manifold And Tube Assembly Removal/Installation (4.0L)
- Condenser To Evaporator Line Removal/Installation
- Blend Door Actuator Removal/Installation
- Panel/Floor Door Actuator Removal/Installation
- Panel Defrost Door Actuator Removal/Installation
- Air Inlet Door Actuator Removal/Installation
- Blower Motor Removal/Installation
- Vacuum Reservoir Tank And Bracket Removal/Installation
- Front Splash Shield Removal/Installation
- Heater Control Unit Removal/Installation
- Heater Control Switch Removal/Installation
- Torque Specifications
- Vacuum Schematic - Manual Climate Control System
- Wiring Diagrams
- Special Tools