Section 36 (Body Exterior - Cabriolet)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- 00 - General, Technical Data
- 50 - Body - Front
- 55 - Hood, Lids
- Hood
- Hood, removing, installing and adjusting (up to model year 2005)
- Hood, removing, installing and adjusting (from model year 2006)
- Gas-filled strut, removing and installing
- Radiator grille, removing
- Catch hook, removing and installing
- Lower portion of hood lock, removing and installing
- Front hood seal (up to model year 2005) - assembly overview
- Front hood seal (from model year 2006) - assembly overview
- Front hood trim, removing
- Hood cable, removing and installing
- Convertible top compartment cover
- Rear lid
- Fuel filler flap
- Hood
- 57 - Front doors, Central locking system
- Front door
- Door, removing and installing
- Window regulator - assembly overview
- Window regulator, removing and installing
- Side impact absorber, removing and installing
- Window regulator, basic setting
- Motor for window regulator, removing and installing
- Door window - assembly overview
- Door window, removing and installing
- Door window, adjusting
- Door hinge - assembly overview
- Front door, adjusting
- Door handle and door lock - assembly overview
- Lock cylinder - assembly overview
- Lock cylinder, removing and installing
- Lock cylinder cover cap, removing and installing
- Door handle, removing and installing
- Door handle trim, removing and installing
- Door lock (up to model year 2005) - assembly overview
- Door lock (up to model year 2005), removing and installing
- Door lock (from model year 2006) - assembly overview
- Door lock (from model year 2006), removing and installing
- Door lock operating rod (from model year 2006), adjusting
- Rear window regulator
- Comfort system
- Component locations
- Notes
- Front Passengers Door Control Module J387
- Radar Interior Monitoring Control Module 2 G305
- Right Rear Window Regulator Motor V27
- Alarm Horn H12
- Motor for fuel tank lid unlock V155
- Motor for rear lid release V139
- Left Rear Window Regulator Motor V26
- Radar Interior Monitoring Control Module 1 G303
- Drivers Door Control Module J386
- Central control module for comfort system J393
- Front hood switch F266
- Fuel filler flap
- Fuel Tank Lid Unlock Motor V155, removing and installing
- Component locations
- Front door
- 61 - Convertible top
- Convertible top, servicing
- Safety precautions
- Rivet connections, loosening
- Convertible top - assembly overview
- Convertible top, removing and installing
- Convertible top lock, removing and installing
- Convertible top locks, checking and adjusting
- Side windows, adjusting
- Convertible top frame seals - assembly overview
- Front roof frame seal, removing and installing
- Rear bracket/roof frame seal or center roof frame seal, removing and installing
- Front rail trim, removing and installing
- Convertible top - parts designations
- Convertible top headliner - assembly overview
- Convertible top headliner, removing and installing
- Convertible top cover - assembly overview
- Convertible top cover, removing and installing
- Convertible top upholstery - assembly overview
- Convertible top upholstery, removing and installing
- Inner headliner, servicing
- Convertible top emergency release
- Convertible top frame
- Convertible top hydraulic system
- Hydraulic system, general information
- Cleanliness rules
- Hydraulic system - assembly overview
- Hydraulic system, function overview
- Notes
- Hydraulic function "open" , raise bracket
- Hydraulic function "open" , convertible top compartment cover open
- Hydraulic function "open" , store bracket.
- Hydraulic function "open" , store convertible top
- Hydraulic function "open" , close convertible top compartment cover
- Hydraulic functions "close" , raise convertible top compartment cover
- Hydraulic functions "close" , raise convertible top from convertible top compartment
- Hydraulic functions "close" , raise bracket
- Hydraulic functions "close" , close convertible top compartment cover
- Hydraulic functions "close" , store bracket
- Hydraulic system, filling and bleeding
- Hydraulic unit (hydraulic pump), removing and installing
- Hydraulic pump housing, removing and installing
- Pump wheel, removing and installing
- Solenoid valve, removing and installing
- Hydraulic lines, removing and installing
- Hydraulic lines to connecting plate, removing and installing
- Hydraulic cylinder, removing and installing
- Convertible top compartment cover latch
- Safety precautions
- Convertible top compartment cover latch - assembly overview
- Left and right convertible top compartment cover locks, removing and installing
- Convertible top compartment cover, adjusting tension plates
- Convertible top compartment cover lock, removing and installing
- Convertible top compartment cover, adjusting drive motor
- Convertible top operation electrical components
- Safety precautions
- Convertible top operation electrical components - assembly overview
- Convertible Top Locking Motor V223/Convertible Top Lock Switch (open) F294/Convertible Top Lock Switch (closed) F295 , removing and installing
- Convertible top position switch (Convertible Top Open Position Switch F171/Convertible Top Closed Position Switch F202), removing
- Convertible Top Frame Position Sensor G356 , removing
- Compartment Cover Open Position Switch F201 , removing
- Convertible Top Control Module J256 , removing
- Transmission Range (TR) Gear Monitoring Switch F290 and Compartment Cover Locked Right Switch 1 F200 , removing
- Convertible Top Front Lock Switch F172 , removing
- Convertible Top Operation Switch E137 , removing
- Convertible top, servicing
- 63 - Bumpers
- Front bumper
- Front bumper (up to model year 2005) - assembly overview
- Front bumper (up to model year 2005), removing and installing
- Front bumper (from model year 2006) - assembly overview
- Front bumper (RS4) - assembly overview
- Front bumper (from model year 2006), removing and installing
- Radiator grille (from model year 2006) - assembly overview
- Bumper cover (up to model year 2005), adjusting to hood
- Bumper crossmember (up to model year 2005), removing and installing
- Bumper crossmember, removing from cover
- Bumper crossmember to impact absorber mount
- Impact absorber, removing and installing
- Rear bumper
- Front bumper
- 64 - Glass, Windows
- 66 - Exterior equipment