A-pillar trim, removing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Remove door seal in A-pillar area and remove A-pillar trim.
- Remove nut - 6 -.
- Drill rivet heads off hollow rivets - 2 - and - 7 - and knock rivet shafts through.
- Remove trim - 1 -.
- Upper and lower retaining clips - 3 - must move to balance out tolerances.
- Retaining clip - 5 - is fixed. It is secured to A-pillar with hollow rivets - 4 -.