Convertible top position switch (Convertible Top Open Position Switch F171/Convertible Top Closed Position Switch F202), removing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Convertible Top Control Module J256

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove rear side trim →
- 70 - INTERIOR TRIM
- 70 - INTERIOR TRIM for BODY INTERIOR - CABRIOLET
.
Disconnect electrical connector on Convertible Top Control Module J256.
Remove convertible top cable from guides and cable ties for body wall and convertible top frame.

Fig 2: Removing Convertible Top Switch Unit Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove switch bolts - 1 -.
Carefully remove convertible top position switch from bolting point mounts.

NOTE:

The convertible top switch unit described is located on the right main guide.
The convertible top should be brought to the appropriate position to remove respective convertible top switch unit bolt.

Tightening torque → Convertible top - assembly overview .