Convertible Top Frame Position Sensor G356 , removing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Convertible Top Frame Position Sensor G356

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Bring convertible top into center position.

Fig 2: Identifying Bolts, Tensioning Cable, Cable Guide & Convertible Top Frame Position Sensor G356

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector on Convertible Top Frame Position Sensor G356 - 3 -.
Remove bolt - B - and carefully remove sensor - 3 - from its mounting opening.

Installation is reverse of removal.

NOTE:

When installing, ensure sensor slides over convertible top linkage synchronization pins.

Tightening torque → Convertible Top Frame Position Sensor G356