Window regulator, removing and installing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Position of adjusting screws and nuts should be marked before loosening.
Removing
- Remove door trim →
- 70 - INTERIOR TRIM
- 70 - INTERIOR TRIM for BODY INTERIOR - CABRIOLET
- Mark position of screws and nuts.
- Run window all the way up.
- Remove window → Door window - assembly overview .
- Remove window regulator motor → Motor for window regulator, removing and installing .
- Remove bass speaker.
- Remove rearview mirror → Side mirror, removing and installing .
- Remove bolts - 1 - , - 3 - and - 4 -.
- Unclip cables.
- Tip rear lower linkage - 5 - forward.
- Tip front upper linkage - 2 - back.
- Remove window regulator from door.
Installing
Installation is reverse of removal.
- After installation, perform basic setting → Window regulator, basic setting .
Tightening torques → Window regulator - assembly overview .