Rear lid, adjusting
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Remove trim for rear panel →
- 70 - INTERIOR TRIM
- 70 - INTERIOR TRIM for BODY INTERIOR - CABRIOLET
NOTE:
- The gas-filled struts must be attached before installing a new rear lid.
- Loosen bolts - 1 - , it must be possible to slide striker - 2 -.
- Carefully close rear lid until lid is flush with side panels.
- Carefully open lid and tighten nuts - 1 -.
2 - Nut (8 Nm)