Rear lid, removing and installing and adjusting: Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Rear lid
- Removing:
NOTE:
- A 2nd technician is needed to support and raise the rear lid.
- Remove rear lid cover.
- Disconnect electrical connectors and remove from lid.
- Remove the nuts that connect both lid hinges to rear lid → Rear lid hinge, removing and installing .
- Install in reverse sequence.
- Panel gap dimensions Panel gap dimensions .
2 - Stop buffer
- Adjusting → Stop buffer, adjusting .
3 - Gas strut
- Removing and installing → Gas-filled strut, removing and installing .
4 - Rear lid hinge
- Removing and installing → Rear lid hinge, removing and installing .
5 - Striker
- Removing and installing Striker, removing and installing .
- Adjusting Rear lid, adjusting .
6 - Nut
- 8 Nm