Gas-filled strut, removing and installing: Notes

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Gas-Filled Strut Remove/Install Components

GW00020492

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

NOTE:

When removing or installing the gas-filled strut, push back the opened rear lid only slightly so as to avoid damaging components.

Lift retaining springs in succession on both ends using screwdriver and remove gas-filled strut - 1 -.

Installing

Clip in gas-filled strut at bottom first, then at top.
Install with tube end of strut at rear lid.