Section 127 (51 - Body Center, Roof, Frame - CARRERA (997))
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- WM 510141 Repairing Threaded Bushing For Belt Connection (All Models)
- WM 5101IN Check Dimensions For Body Diagnosis (Repairs) (TARGA 4 & TARGA 4S)
- WM 510355 Replacing Roof (All Models)
- WM 510555 Replacing Roof Pillar (Pipe) (All Models)
- Tools
- General Warning Notes
- Tools And Materials
- Preliminary Work For Body Repairs With Alignment Bench
- Removing Roof Pillar (Pipe) And Roof Frame Reinforcement
- Preparing Connection Areas Of The Body For Installing The Roof Pillar (Pipe) And Roof Frame Reinforcement
- Fitting Roof Pillar (Pipe) And Roof Frame Reinforcement And Preparing For Installation
- Installing Roof Frame Reinforcement And Roof Pillar (Pipe)
- Subsequent Work
- WM 510955 Replacing Rear Cross Member (Side Impact Reinforcement) (All Models)
- Tools
- General Warning Notes
- Tools And Materials
- Preliminary Work For Body Repairs With Alignment Bench
- Removing Rear Cross Member (Side Impact Reinforcement)
- Preparing Connection Areas Of The Body For Installing The Rear Cross Member (Side Impact Reinforcement)
- Fitting Rear Cross Member (Side Impact Reinforcement) And Preparing For Installation
- Installing Rear Cross Member (Side Impact Reinforcement)
- Subsequent Work
- WM 511155 Replacing Windscreen Frame (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster)
- WM 511155 Replacing Windscreen Frame (CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster)
- WM 512119 Removing And Installing Rear Centre Panel (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster)
- WM 512137 Disassembling And Assembling Rear Centre Panel (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster)
- WM 512155 Replacing Rear Centre Panel Reinforcement (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster)
- Tools
- General Warning Notes
- Tools And Materials
- Preliminary Work For Body Repairs
- Removing Rear Center Panel Reinforcement
- Preparing Connection Areas Of The Body For Installing Rear Center Panel Reinforcement
- Preparing Rear Center Panel Reinforcement For Installation
- Installing Rear Center Panel Reinforcement
- Subsequent Work
- WM 513755 Replacing Outer Hinge Pillar (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster)
- WM 514555 Replacing Outer Side Member (CARR. 4 Coupe, Turbo Coupe, CARR. 4S Coupe, TARGA 4, TARGA 4S, Gt2, Gt2 RS & Gt3 RS)
- WM 514855 Replacing Centre Side Member (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster)
- WM 514855 Replacing Centre Side Member (Rear Section) (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster)
- Tools
- General Warning Notes
- Tools And Materials
- Preliminary Work For Body Repairs
- Removing Center Side Member (Rear Section)
- Preparing Connection Areas Of The Body For Installing The Center Side Member (Rear Section)
- Fitting In Center Side Member (Rear Section) And Preparing For Installation
- Installing Center Side Member (Rear Section)
- Subsequent Work
- WM 514955 Replacing Lower Side Member Reinforcement (Support Tube) (All Models)
- Tools
- General Warning Notes
- Tools And Materials
- Preliminary Work For Body Repairs With Alignment Bench
- REMOVING LOWER SIDE MEMBER REINFORCEMENt
- Preparing Connection Areas Of The Body For Installing Lower Side Member Reinforcement
- Fitting Lower Side Member Reinforcement And Preparing For Installation
- Installing Lower Side Member Reinforcement
- Subsequent Work
- WM 516255 Replacing Hinge Pillar Reinforcement (Except CARR. CABRIO, CARR. S CABRIO, CARR. GTS CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, Turbo S CABRIO & Speedster)
- Tools
- General Warning Notes
- Tools And Materials
- Preliminary Work For Body Repairs With Alignment Bench
- Removing Hinge Pillar Reinforcement
- Preparing Connection Areas Of The Body For Installation Of Hinge Pillar Reinforcement
- Fitting Hinge Pillar Reinforcement And Preparing For Installation
- Installing Hinge Pillar Reinforcement
- Subsequent Work
- WM 516319 Removing And Installing Deformation Element (All Models)
- WM 516819 Removing And Installing Dashboard Support (All Models)
- WM 518741 Repairing Threaded Bushes For Seat Cross Member (All Models)
- WM 518755 Replacing Seat Cross Member (All Models)
- WM 518941 Repairing Threaded Bushes For Suspension SUBFRAME Installation (All Models)
- WM 519219 Removing And Installing Cover For Front Underbody (All Models)
- WM 519319 Removing And Installing Cover For Centre Underbody (All Models)
- WM 519419 Removing And Installing Cover For Rear Underbody (Turbo Coupe, Turbo S Coupe, Turbo CABRIO, Turbo S CABRIO, Gt2, Gt2 RS, Gt3 & Gt3 RS)