Preliminary Work For Body Repairs: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- If it can be ensured there has been no deformation of the vehicle structure, the following repair can be carried out without the need of a straightening bench. In this case, the vehicle must not be raised when welding the component; it must stand on its wheels on an even surface.
- Remove accessories in the repair area
- 1.1. Remove accessories in the repair area according to the extent of damage to the vehicle.
- Equip straightening bench with straightening attachments
- 2.1. Equip straightening bench with the straightening attachments according to the setup plans included with the straightening attachments.
- Place vehicle on the straightening bench
- 3.1. Position vehicle on the straightening bench, align according to the reference holes and bolt firmly to the straightening attachments.
- Cover accessories adjacent to the vehicle repair area
- 4.1. Cover all accessories remaining on the vehicle and adjacent areas with fire-proof protective covers.
- Reshape connection area of the sheetmetal parts to be replaced
- Expose welding areas
- 6.1. Remove undersealing, paint, etc. from the welding areas of the body with a hot-air gun or rotary brush.